USDR SDR Transceiver All Mode 8 Band HF Ham Radio QRP CW Transceiver USB, LSB,CW

Description USDR SDR Transceiver All Mode 8 Band HF Ham Radio QRP CW Transceiver 80M/60M/40M/30M/20M/17M/15M/10M Description: uSDR is optimized and modified based on the open source work uSDX/QCX-SSB. uSDX/QCX-SSB GitHub: https://github.com/threeme3/QCX-SSB/tree/feature-rx-improved This is a shortwave QRP SSB/CW transceiver. The ultra-small size makes it easy to carry for outdoor use. It adopts 1602N LCD screen, built-in speakers. Support to connect to PC and use FT8, JS8, FT4 and other digital mode software control, support CW automatic decoding. Features: – 8 band coverage 80m/60m/40m/30m/20m/17m/15m/10m – Excellent PCB layout design in line with high-frequency circuit design principles to ensure excellent performance – Can reach 3-5W power in 8 bands and reserve TO-220 package pads required for upgrades – High emission efficiency, 80m/60m/40m/30m/20m efficiency is higher than 85%, 17m/15m efficiency is higher than 80%, 10m efficiency is higher than 70% – High-precision for KDS brand TCXO, frequency accuracy is better than 1PPM, frequency stability is better than 0.5PPM – Independent core board and RF board to avoid own signal interference. – Ultra-small size: 82.8 x 28.8 x 110mm/3.3 x 1.1 x 4.3″ (excluding protruding parts) – Rich interfaces (CAT, PTT OUT, MIC/KEY, K-head microphone) – All LPF parts use 100V C0G/NP0 capacitors – Use original genuine Omron magnetic latching relay – Use original genuine LM4562 or LM833 op amp chip – Built-in speaker with cavity – BNC antenna interface Function List: – Simple, fun and versatile QRP SSB HF transceiver with embedded DSP and SDR functions – EER Class-E driven SSB transmit-stage – Approximately 5W PEP SSB output from 13.8V supply – All-Mode support: USB, LSB, CW, AM, FM – DSP filters: 4000, 2500, 1700, 500, 200, 100, 50 Hz passband – DSP features: Automatic Gain Control (AGC), Noise-reduction (NR), Voice-triggered Xmit (VOX), RX Attenuators (ATT), TX noise gate, TX drive control, Volume control, dBm/S-meter – SSB opposite side-band/carrier suppression transmit: better than -45dBc, IMD3 (two-tone) -33dBc, Receive: better than -50dBc – Multiband support, continuously tunable through bands 160m-10m (and from 20kHz..99MHz with loss in performance) – Open source firmware, built with IDE for Arduino; allows experimentation, new features can be added, contributions can be shared via Github, software-complexity: 2000 lines of code – Software-based VOX that can be used as fast Full Break-In (QSK and semi-QSK operation) or assist in RX/TX switching for operating digital modes (no CAT or PTT interface required), external PTT output/PA control with TX-delay – Simple to install modification with 8 component changes and 8 wires – Lightweight and low-cost transceiver design: because of the EER-transmitter class-E stage it is highly power-efficient (no bulky heatsinks required), and has a simple design (no complex balanced linear power amplifier required) – Fully digital and software-based SSB transmit-stage: samples microphone-input and reconstruct a SSB-signal by controlling the phase of the SI5351 PLL (through tiny frequency changes over 800kbits/s I2C) and the amplitude of the PA (through PWM of the PA key-shaping circuit) – Fully digital and software-based SDR receiver-stages (optionally): samples I/Q (complex) signal from Quadrature Sampling Detector digital mixer, and performs a 90-degree phase-shift mathematically in software (Hilbert-transform) and cancels out one side-band by adding them – Three independent switchable analog front-end receiver attenuators (0dB, -13dB, -20dB, -33dB, -53dB, -60dB, -73dB) – Receiver Noise level MDS: -135 dBm at 28MHz (in 200Hz BW) – Receiver Front-end selectivity: steep -45dB/decade roll-off +/-2kHz from tuned-frequency – Blocking dynamic range: 20kHz offset 123dB, 2kHz offset 78dB – CW decoder, Straight/Iambic-A/B keyer – VFO A/B + RIT and Split, and corresponding relay band-filter switching via I2C – CAT support (TS480 subset) Specifications: – Type: HF QRP SDR Transceiver – Mode: SSB/CW – Rf output: 10W max at 13.8V exit DC in – Frequency range: 3.5-30MHz – Built-in MIC – Antenna/connector: 50ohms/SO-239 Package Included: – 1 x Transceiver – 1 x Mic Payment Terms 1. We accept PayPal,Payoneer,Visa Card,Google pay,Credit card etc. 2. We ship to your eBay or Paypal address. Please make sure your eBay and Paypal address is correct before you pay. Shipping Terms 1. We will process the order within the handling time ,if you have any questions, please contact us via eBay message or email. 2. For remote regions of DHL/FedEx…, extra shipping costs might be charged. Usually it costs about 30USD-50USD. We will contact you if shipping company informed us your address belongs to remote area. Thanks for your understanding. Return Terms If you receive the item that not satisfied or defective, please do not open case and kindly notify us within 30 days. We will guide you the returning process for replacement or refund. Custom Duties & Taxes 1. It is buyer’s responsibility to cover the import duties, taxes.We do not charge any taxes and fees, and the possible taxes and fees will be collected by the platform or by third parties such as customs and carriers. 2. Please check with your country’s customs office and inform us what/how much should declare before shipping. Feedback 1. Please kindly leave us a positive feedback and 5 star DSR if you satisfied with our product and service. Please feel free to contact us firstly if you have any problem with your order, we are responsible and credible seller and will solve the issue it for you asap. 2. If you are dissatisfied for any reason, please don’t be quick to leave us neutral or negative feedback. We work hard to make sure EVERY CUSTOMER 100% SATISFIED and resolve any problem for you and always leave positive feedback to all our customers.