Line Stroft LS Monofilament 50m Leader Monofilament Polyamide Transparent

Line STROFT LS Monofilament 50m Line STROFT LS Monofilament 50m Outstanding properties compared to other polyamide lines. Item no.: ST-LS-78XX Product description Outstanding properties compared to other lines made from polyamide alloys: Low stretch Highest linear load capacity Highest knot load capacity The STROFT LS was developed based on a new polyamide alloy. The tuning focus is on reducing stretch while ensuring the highest possible tensile strength. This is what the abbreviation LS stands for (Low Stretch). The elongation properties diagram shows for STROFT LS (purple) an elongation at break (at 100% line load) of approx. 17%. This is significantly lower than with other lines made of polyamide or lines made of fluorocarbon. Also in the area of initial stretch (approx. 50% line load) lies LS with an elongation of approx. 9% significantly lower. (Only UHMWPE braided lines have an even lower stretch). In the area of fine load elongation (approx. 10% line load), LS is also below the other polyamide lines, but slightly above Fluorocarbon. The tensile strength values (on average for all diameters between 0.10mm and 0.60mm) are the highest that have been achieved with monofilaments to date. This applies to both the tensile strengths with knots and the tensile strengths without knots. In the area of thinner diameters, the values are still similar to the GTM, but then increase continuously. The 0.60mm STROFT LS carries an impressive 33.0 kg! So if the lowest possible elongation with the highest possible load capacity is important and a slightly greater rigidity can be accepted, STROFT LS is the first choice. The slightly greater rigidity also requires a slightly larger memory, which can also have a negative impact when tying knots (depending on the type of knot). If such a knot is not tied correctly, the cord may curl slightly. The same applies to practical use, for example due to a sharp edge. However, if this curling is not too severe, it can be removed relatively easily. If this is taken into account, STROFT LS should also be interesting for fly fishermen. The slightly higher stiffness, compared to softer lines, favors the stretching and rolling behavior of the fly leader, especially that of the tippet tip. specification Manufacturer: Stroft Cord length: 50 m Cord type: Monofilament Color: Light gray transparent Made in: Germany Model: L.S Product: L.S Material: nylon Type of fishing: Freshwater fishing, saltwater fishing The tensile strength values (on average for all diameters between 0.10mm and 0.60mm) are the highest that have been achieved with monofilaments to date. This applies to both the tensile strengths with knots and the tensile strengths without knots. In the area of thinner diameters, the values are still similar to the GTM, but then increase continuously. The 0.60mm STROFT LS carries an impressive 33.0 kg! So if the lowest possible elongation with the highest possible load capacity is important and a slightly greater rigidity can be accepted, STROFT LS is the first choice. The slightly greater rigidity also requires a slightly larger memory, which can also have a negative impact when tying knots (depending on the type of knot). If such a knot is not tied correctly, the cord may curl sl