Apps2Car 3M Vhb Sticky Adhesive Pads Replacement Mounting Tape 4 Pcs, Dashboard

Strong Stickness: Original 3M Vhb stick adhesive pads, Double sided self sticky, 1.55mm thickness GPH 160 Vhb adhesive pads, stronger than most adhesive pads even in high temperature. Suitable for stick many kinds of material with flat hard surface. It can be used in home bathroom mirror, refrigerator, bed post, wall, locker, office, driving personnel and other related equipment replacement. Rectangular 3M Vhb sticky adhesive tape can be used on the bottom of the most dashboard 360 degrees Rotation magnetic car phone mount holder, which is stable even in bumpy roads. It is a strong sticky adhesive replacement for phone car mount. Compatible with Wizgear, Bextrix, Scosche ,Trainium ,PLDHPRO ,Ailun etc. magnetic phone car mount. This 3M Vhb adhesive pad is high-temperature resistance and low-temperature resistance, water-proof, Tear off non-trace. Note: (1)Please don’t stick the 3M adhesive pad on a very soft, rugged, texture, grease surface or leather surface. (2)Make sure the desired surface is clean and dry. (3)The 3M Vhb adhesive pad is for one-time use. (4)It is recommended to wait at least 24 hours to ensure the sticker gets the best stickiness before use. (5)Worry-free: APPS2Car comes with a worry-free lifetime and excellent customer service. Product Description Note: 1,Please don’t stick the 3M stick adhesive pad on very soft, rugged, texture,grease surface or leather surface. 2,Please remove the residual glue and clean the surface. 3,The 3M Vhb adhesive pad is one-time use. please sealed preservation. 4,It is Recommended to wait at least 24 hours after stuck before using. The longer the adhesive time, the stronger the viscosity will be. 5,Peel off the yellow protective film and press it at least 2 minutes then wait for about 2 hours before peel off the other side red film. If the red protective film is hard to peel off, please press it back once and try to peel off it again, don’t touch the gel with your hand after peel off. Easy installation： Step 1,Remove the residual glue. Step 2,Clean and dry the car phone mount base completely. Step 3,Tear off the yellow protective film. Step 4,Stick it on the car phone mount base and press it at least 4 minutes for better connecting to the base, then wait for about 2 hours to tear off the other side red film. Step 5,Clean and dry the smooth and hard flat surface thoroughly to ensure there is no dust or debris. Step 6,Tear off the other side red protective film, Then stick it on the cleaned dash surface firmly and press it at least 5 minutes to ensure that the adhesive pad and the surface fully bond.It is recommended to wait for at least 24 hours before use. If you hard to tear off the red protective film, please press it back ,then tear off it again.Don’t touch the gel with your hand after peel off the film. Package include: 4 X 3M Vhb adhesive pads 1 X use manual