Aluminum Electrolytic Capacitor 25V 10000UF 18x35mm Plug-in

项目ltem 特性Performance Characteristics 適用溫度範圍 Operating Temperature Range -40to+105℃ -25to+105℃ 工作電壓範圍 Rated Voltage Range 6.3to100VDC 160to450VDC 靜電容量误差 Capacitance Range 0.1to4700μF 0.47to220μF 电容量允差 Capacitance Tolerance ±20%（100Hz or 120Hz，+20℃） 洩漏電流 Leakage Current （+20℃，最大max） I≤0.01CV或5（μA）額定工作電壓充電1分鐘後讀數，取大者 I≤0.01CV or 5(μA) After1minutes,whichever is greater measured with rated working voltage applied I≤0.03CV+10（μA）額定工作電壓充電1分鐘後讀數，取大者 I≤0.03CV+10(μA) After1minutes,whichever is greater measured with rated working voltage applied 散逸因素 (tan δ) Dissipation Factor（tgδ） 工作電壓WorkingVoltabe(VDC)6.3101625355063100160200250350400450D.F(%)最大2220181414121210141414151517 容量>1000μF时，每增加1000μF D.F值增加2%( 100Hz or 120Hz，+20℃) For capacitance1000μF,Add 2%per another 1000μF (100Hz or 120Hz，+20℃) 低温特性 Low Temperature Characteristics （120Hz） 阻抗比，最大Impedance ratio ,max 工作电压Working Voltage(VDC)6.3101625355063100160200250350400450Z – 25℃ / Z+20 ℃432222222235615Z – 40℃ / Z+20 ℃86433333—— 容量>1000μF时，每增加1000μF ，Z – 25℃ / Z+20 ℃值增加0.5%, Z – 40℃ / Z+20 ℃值增加1% Fpr capacitance>1000μF , and 0.5% per another 1000μF for Z-25℃/Z+20℃, add 1% per another 1000μF for Z-40℃/Z+20℃ 負荷壽命Load Life 試驗條件 Test conditions 持續時間:8000~12000小时 Duration time: 2000hours 環境溫度:+105℃ Ambient timperature: +105℃ 施加電壓:額定工作電壓(VDC) Applied voltage: Rated Working Voltage(DVC) 施加額定紋波電流 Applied voltage: Rated Working Voltage(mA) 試驗後要求:室溫下恢復16小時,+20℃測試 After test requirements: Resumde 16 hours at normal temperature 電容量變化:≤20%規定值 Capacitance change:≤20% of the initial measured value 損耗角正切值:≤200%初始值 Dissipation Factor:≤200% of the initial specified value 漏電流:≤規定值 Leakage Current:≤The initial specified value 放置壽命Shelf Life 試驗條件 Test conditions 持續時間:1000小时 Duration time: 500hours 環境溫度:+105℃ Ambient temperature:+105℃ 施加電壓:無 Applied voltage: None 試驗後要求:室溫下恢復16小時,+20℃測試 After test requirements: Resumed 16 hours at normal timperature 電容量變化:≤20%規定值 Capacitance change:≤20% of the initial measured value 損耗角正切值:≤200%初始值 Dissipation Dissipation Factor:≤200% of the initial specified value 試驗條件漏電流:≤200%規定值 Leakage Current:≤200% of the initial specified value ●試驗條件紋波電流頻率調整系數 ●紋波電流溫度調整系數 Multiplier for ripple current vs.frequency Multiplier for ripple current vs.temperature 容量（μF）/ Hz 60(50) 120 400 1K 10K 50K~100K 溫度℃ 45 60 70 85 105 系數 ≤10 0.8 1 1.30 1.30 1.65 1.70 系數 2.10 1.90 1.40 1.25 1.00 10~100 0.8 1 1.23 1.23 1.48 1.53 100~1000 0.8 1 1.16 1.16 1.35 1.38 >1000 0.8 1 1.11 1.11 1.25 1.28 ● DIMENSIONS(mm) DФ 5 6.3 8 10 13 16 18 22 F 2 2.5 3.5 5.0 5.0 7.5 7.5 10 dФ 0.5 0.6 0.8 On Dec 10, 2023 at 23:14:12 PST, seller added the following information: