4 pcs x 6P36S ~ EL500 ~ 6GB5 QUAD Power Output Beam Tetrode VINTAGE USSR TUBES

6P36S ~ EL500 ~ 6GB5 LOT 4 pcs NEW TECHNICAL DATA 6P36S The 6P36S (6П36С) output beam tetrode is designed for operation in line scanning units of widely used television receivers having a kinescope beam deflection angle of 110. The 6P36S output beam tetrode are miniature devices enclosed in glass bulb and are provided with eight flexible leads and an indirectly heated oxide-coated cathode. The 6P36S electorn tube output beam tetrode are resistant to ambient temperature from -60 to +70°C and relative humidity of 95 to 98% at +40°C, as well as to mechanical loads: vibration loads up to 2.5g and multiple impact loads up to 12g. Near equivalent: EL500 and 6GB5. General characteristics: Name: 6P36S Type: Output beam tetrode Application: Application in TV scan modules Cathode type: oxide, indirect heating Envelope: glass Mass, g: 90 Filament voltage, V: 6,3 Filament current, A: 1,8-2,2 Anode voltage, V: 100 Anode current, A: 0,07-0,17 Anode power, W: 12 Grid1 voltage, V: minus 7 Grid2 voltage, V: 100 Steepness, mA/V: 14 Reverse grid current, uA: 1 Microphnic noise, mV: 1000 Socket type: rsh24-2 IMPORTANT INFORMATION! BE SURE TO READ BEFORE ORDERING! In the title of the lot is the name of the vintage Soviet tube and after the symbol ~ the name of the Western analog. Be careful! Soviet tubes are only approximate analogs of Western tubes and match pinout, but are not exact copies of Western tubes. Testing Soviet tubes with Western-made tube testers can sometimes show unreliable results. Programs (Cards) designed for testing Western tubes can sometimes show unreliable results and erroneously show that the tube is not good enough. But these are unreliable results and should be disregarded. The volt-ampere characteristics of Soviet tubes are different from their Western analogs! Use for testing exclusively testers with programs for testing Soviet tubes. If you would like to get the datasheet for the Soviet tubes in this lot, please send me a message before you place your order and I will send you a JPG datasheet for the Soviet tube. Also, do not test vintage tubes with modern digital pulse powered tube testers. Use only testers with a classic power supply. For reliable measurement results, warm up each tube for at least 5 minutes prior to measurement. I do not accept any claims on the quality of tubes if you test purchased Soviet tubes of this lot on testers with programs (modes) of testing Western tubes or test tubes on digital testers with pulse power supply. Dear customer, you can combine shipping buying more than one lot. If You need more than one lot, or another quantity – please contact. Also please check other available items. Thanks in advance!