190003 Tension Control Clamp Kit For Pentair Pentair FNS DE Series Pool Filter

l 【 HIGH QUALITY 】 Long life-span matters, that is why our 190003 filter tank clamp kit is made of high-quality material which prevent leak and premature failure to ensure it can work for a long time l 【 FUNCTION 】 The filter clamp kit is used for cleaning and maintenance of a cartridge or DE filter, keeps a tight seal between the two filter halves, replacing the clamp is a simple and convenient process l 【 FEATURE 】 As time goes on, the filter clamp starts to get old and the threads will begin to strip, if the clamp breaks the filter tank top will explode off. Replace the filter clamp, you can protect your filter, will not cause you too much loss l 【 APPLICATION 】 The tension control clamp assembly 190003 replacement for Clean and Clear Plus, FNS Plus, Quad pool and Aspa D.E. filters l 【 12-MONTH WARRANTY 】 If you have any other questions about the filter clamp ring, please contact us anytime and we will be glad to assist you. Your satisfaction is the direction we have been working towards Features:Easy to Install, Strong and durable, Easy to tighten the knob Including: Tension Clamp, Spring Barrel Nut Assembly Used On: Pentair Clean & Clear Plus Filters Pentair FNS Plus DE Filters Pentair Quad DE Filters Pentair Pac Fab FNS DE Filters Filter Clamp Installation: Follow these instructions exactly to prevent the lid from separating during system startup or operation. 1. Turn off the pump and any automatic controls. 2. Open the Air Relief Valve and turn counterclockwise until it snaps into the full open position. Wait until all pressure is relieved before assembly, disassembly, or servicing. 3. Be sure the O-ring is clean and in position on the lower tank half. Place the FNS Plus Vertical Grid D.E. Filter lid onto the lower tank half so the O-ring fits in between the tank halves. 4. Hold the ends of the filter clamp apart and place over both upper and lower tank flanges. Bring the ends of the filter clamp together. 5. Insert the T-bolt through the other side of the clamp and hold together. 6. Place the small washer onto the T-bolt. 7. Place the larger washer and spring onto the barrel nut then place onto T-bolt and tighten the nut by hand. Be sure filter clamp is fully engaging both tank flanges. 8. First tighten the nut using a 7/8 in. wrench and then tap around the outside of filter clamp with a rubber mallet (or similar tool) multiple times around the entire clamp to fit the clamp properly. Continue to tighten only until the spring coils touch. Quality Guarantee : 12 -Month Warranty At Paddparts Store , we take pride in the quality of our products and in your satisfaction. If you have any problems, do not hesitate to contact us.